User`s manual

E-10

5 RGB Input 2 Connector (Mini D-Sub 15 pin)

Connect a Macintosh or compatible computer here using the

signal cable and the monitor adapter that is supplied. Or

connect your PC or other RGB equipment such as IBM or

compatible computers. Use the signal cable that is supplied

to connect to a PC.

RGB 2 Audio Input Mini Jack

This is where you connect a second RGB audio output from

a computer or another RGB source.

6 PC Control Port

Use this port to connect your PC to control the MultiSync

MT1035 Projector. This enables you to use your PC and

serial communication protocol to control the projector. If

you are writing your own program, command references are

on page E-45.

A cap is put on the port at the factory. Remove the cap when

using the port.

7 Mouse Output Port

Use this port to operate your computer’s mouse functions

from the NEC MultiSync MT1035 remote control. When

your computer is connected here, the remote sensors on the

LCD projector cabinet will receive your mouse commands.

8 Remote Control Jack

Connect your remote control cable here for wired operation.

9 Built-in Security Slot ( )

This security slot supports the MicroSaver

Security Sys-

tem.

MicroSaver

is a registered trademark of Kensington

Microware Inc. The logo is trademarked and owned by

Kensington Microware Inc.

PC CONTROL MOUSE OUTPUT

REMOTE

CONTROL

INPUT

AUDIORGB INPUT 2

AUDIORGB INPUT 1

AUDIORGB MONITOR OUTPUT

RL/MONO

INPUT AUDIOS–VIDEO

RL/MONO

INPUT AUDIOVIDEO

678

AC IN