Owner`s manual
Table Of Contents
- Contents
- Chapter 1 - Introduction and Description
- Chapter 2 - Installation
- Chapter 3 - Software Installation
- Chapter 4 - Troubleshooting
- Introduction
- The Card Service does not enable my card
- How do I know the FAST Ethernet PC card is
- How do you enable the FAST Ethernet PC card?
- How do you make the card work under Systemsoft Card Service?
- How do you make the card work under Phoenix Socket/Card Service?
- How do you make the card work under Award Socket/Card Service?
- How can the ODI driver run successfully but fail to login to the Netware server?
- What to do should your Driver installation fail
- Chapter 5 - Service
- Appendix A - Regulatory Agency Information
- Index
Troubleshooting
32-MultiMobile
Q:How do you enable the FAST Ethernet PC card?
A:1.The Fast Ethernet PC Card can be enabled by the
Card Service installed in the laptop directly. The
drivers associated with the card in the driver dis-
kette can be run over Card Service directly.
2.In case the Card Service cannot enable the
PCMCIA card, you can run LANEN to enable it.
Q:How do you make the card work under
Systemsoft Card Service?
A:1.Copy across the LE100.CLB file.
Copy FROM
A:\PCMCIA\CARDSOFT\LE100.CLB
TO
C:\CARDSOFT\LE100.CLB
Contingent upon where the Cardsoft is saved.
2.Edit the CARDID.INI file and add the library
LE100.CLB.
Edit C:\CARDSOFT\CARDID.INI
Find the section which starts [Libraries], and
add the line
CardLib=le100.clb
before any other CardLib= lines.
When the card is inserted it will beep. Use
CARDINFO /V to check if the card has been con-
figured correctly.
3.If the card cannot work properly, you may edit
CARDID.INI again to change the resources allo-
cation.
In the [Common] section you may find the follow-
ing strings:
Lan1Port=300
Lan1IRQ=5
Lan1MemoryBase1=D0