Owner`s manual
Table Of Contents
- Contents
- Chapter 1 - Introduction and Description
- Chapter 2 - Installation
- Chapter 3 - Software Installation
- Chapter 4 - Troubleshooting
- Introduction
- The Card Service does not enable my card
- How do I know the FAST Ethernet PC card is
- How do you enable the FAST Ethernet PC card?
- How do you make the card work under Systemsoft Card Service?
- How do you make the card work under Phoenix Socket/Card Service?
- How do you make the card work under Award Socket/Card Service?
- How can the ODI driver run successfully but fail to login to the Netware server?
- What to do should your Driver installation fail
- Chapter 5 - Service
- Appendix A - Regulatory Agency Information
- Index
Troubleshooting
33-MultiMobile
Lan1MemoryBase2=D4
Lan2Port=320
Lan2IRQ=11
Lan2MemoryBase1=D8
Lan2MemoryBase2=DC
You may change the Lan1Port or Lan1IRQ to another
value (e.g. Lan1Port=320, Lan1IRQ=11) to request
Cardsoft allocate the resources you wanted.
4.If the resources cannot allocate properly, you may
run \CARDSOFT\CONFIG
or edit \CARDSOFT\CSALLOC.INI directly to set
the system resources available for allocation. The file
content of CSALLOC.INI are listed as below:
# The available resources described by the MEM=,
IO=, and IRQ= lines
# It may have been altered by the xINCLUDE and/
or xEXCLUDE lines below!
# The MEM=, IO= and IRQ= lines are provided
for Read-Only purposes.
#
MEM=D000-DFFF
IO=100-3F7
IRQ=5,7,9-C,E-F
#
# *** Resource modifications should be made below
this line. ***
#
RIO=170-177,370-377
MEMEXCLUDE=C000-CFFF,E000-EFFF
IOEXCLUDE=3F8-3FF,2F8-2FF
IRQEXCLUDE=3-4,6,13-14
You may edit the file to guide the Cardsoft which
resources are available in your computer.