Owner`s manual
Hardware Installation
10-MultiMobile
2. Plug the 15 pin connector into the 15 pin socket of
the PC card. On the other end of the 15-pin cable,
leave the RJ-45 network cable exposed until the
LAN connection is made; hardware installation is
now complete. The MT10ZLX/E is powered di-
rectly from the PC.
2a. Determine if your LAN connection is 10Base-T or
10Base2. Plug the 15 pin connector into the 15 pin
socket of the PC card. On the other end of the 15-
pin cable, leave RJ-45 cable (10Base-T), or BNC
T-cable receptacle (10Base2) exposed until LAN
connection is made; hardware installation is now
complete. The MT10ZLX/E-T/2 is powered di-
rectly from the PC.
3. Connect the MT10ZLX/E to the network (LAN)
using the bundled RJ-45 (8-pin) plug.
3a. If youve determined that your LAN connection
requires a 10Base2 connection, connect the
MT10ZLX/E-T/2 to the network (LAN) using the
media coupler thin net cable connection. Allign
the notches of the cable to that of the BNC T-con-
nector, and twist clock wise approximately one-
quarter turn. Otherwise, follow step 3 for 10Base-
T connection.
For operation in a 10Mbps (10Base-T) Ethernet net-
work, a Category 3, 4 or 5 UTP cable could be used to
connect between the media coupler and a 10Mbps hub
or switch. Speak to your Network Administrator for
more details.
*: Removal of this PCMCIA card from a notebook com-
puter is contingent upon notebook computer design.
Please refer to PC Card removal instruction specific to
your notebook computer.