Owner`s manual

Troubleshooting
30-MultiMobile
Chapter 4 - Troubleshooting
Introduction
This chapter provides a number of examples of Ques-
tions (Q:), Causes (C:), and Answers (A:). If your
Ethernet PC card is not working properly, look up the
solution here; if unsuccessful, call Tech Support (see
Chapter 5).
Q:The Card Service does not enable my card. When
I run LANEN, the error message displays Fail to
enable PC card. Why?
C:No memory space to map the attribute memory of
PCMCIA card.
A:If memory management software e.g. EMM386 has
been installed, you have to reserve some area in up-
per memory (C000:0  EFFF:F) for attribute
memory of PCMCIA card while enabling the card.
Example: Device=C:\DOS\EMM386.EXE RAM
X=D000-D3FF. Reserve D000 - D3FF for attribute
memory.
Q:How do I know the FAST Ethernet PC card is
enabled?
A:1.If the Card Service is installed, you will hear a beep
when card is inserted.
2.Run LANEN /CHK to check if the card is en-
abled. The resources allocated for the card are
shown at the last line of the display message.
 IO=xxx IRQ=nn Slot=nn