User manual

Then click on the Test the connection… button.

By entering AT and clicking on the Enter button the M1 should answer

OK.

The command AT+CSQ indicates the signal quality (a number between

0 and 31, where 31 is the best).

The command AT+COPS? shows whether you have been registered on

the network or not. It should reply with the name of your network

operator.

Now the M1 should be programmed to be in auto-answer mode with a

non-transparent error correction protocol and the result codes should

be disabled.

Enter the commands from Table5 , one by one.

After finishing programming you will notice that the M1 no longer indi-

cates OK to every command, that is because the ATQ1 command has

disabled the output of the results codes. Result codes must be disabled,

otherwise 2260 will try to interpret these messages.