Owner`s manual

MT3334ZDX/V Owner's Manual
16
Remote Configuration
The Remote Configuration feature is a network management tool that
allows you to configure modems remotely. This means you could
configure modems anywhere in your network from one location without
having to visit the sites or rely on remote users to follow your instructions.
You can download new parameters and implement new features.
S-Register S9 has been set up to contain the special Remote Configuration
escape code. When calling a Remote Configuration equipped modem,
you enter the proper Remote Escape Code entering your Set-up Password.
You can then execute AT commands as if you were connected locally. If
you set S-Register S9 to 0 (zero), Remote Configuration is disabled.
Setting S9 to a value other than zero, defines the escape key. For
example, if S9 = 37, the % (percent sign) would be the escape key. The
S9 value can be stored with the &W0 command.
To store the remote configuration password, type the following:
AT#S=password<RETURN>
The password can be from 1 to 8 characters in length and is case
sensitive. This password can be changed in command mode but not in
remote configuration. If no user password has been stored, the default
password is "MTSMODEM". If a user password has been set, the default
password is disabled.
To enter Remote Configuration from online mode, enter the value in S9
three times, the type ATpassword <RETURN>. For example:
If S9 = 37, enter: %%%ATpassword<RETURN> and you will be
in command mode.
Note: If an AT&F (load factory defaults) command is entered, or if an ATZ
(modem reset) command is entered and S9 has not been saved, S9 will
return to zero. However, if either of these two commands are entered, the
password will remain saved.