Technical data

Connect failed: NO LINE or NO CARRIER
The DAS now begins the process of uploading data for each of the enabled upload channels. Example messages are shown
below:
Uploading Ch N: / Sending Status
The DAS is sending its status (system health, etc.) to the server configured for upload channel #1:
Uploading Ch N: / Sent XX% Data
Next the DAS sends any queued meter data for channel #1, and periodically reports the % of data it has sent so far.
Uploading Ch N: / Sync Config
Finally, the DAS synchronizes its configuration files with the server for channel #1. This process is covered in detail in the
AcquiSuite Module Developer's Manual. For now, it is enough to know that the DAS will compare the MD5 signatures of
each configuration file against those on the server, and if there are any differences it will either download or upload
configuration files depending on whether the local or remote file is newer.
Page 22 USB Modem Addendum