Technical data

Step 4: Enable & Configure Dial-In
“Dial-in” allows the DAS to be remotely administered and allows data to be “pulled” from the DAS using Obvius'
EnerTraxDL software.
“Dial-in” is not supported with cellular modems. It is supported with all “POTS” modems, including all USB “POTS”
modems.
To enable dial-in, check the “Dialin Enabled” box in the DAS's “Dialin Setup” web page and click Apply. Like so:
Within 10 to 20 seconds, the DAS's LCD should show the message “Ready for Incoming Call”, like so:
If the DAS encounters problems while preparing the modem to receive incoming calls, it will display messages such as these
on the LCD display. These will be updated every few minutes until the problem is corrected or “dial-in” is disabled.
Page 25 USB Modem Addendum