User guide

Chapter 3 – Setting Country Codes Using the CLI
Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 64
Chapter 3 – Setting Country or
Region Codes Using the CLI
The Default Country or Region Code is B5.
If You Want to Change the Country or Region Code, Use the Command Line Interface:
Command Syntax set serial s1 modem country-code value <value>
Description
Sets the modem country/region code value to <value>.
This command is valid only for port s1. Applicable only if the country-code type is set
to code.
Default Value
-
Success
OK
Error 1. Too few arguments
“Usage: set serial s1 modem country/region-code value <value>
Type ‘set serial s1 modem country/region-code value ?’ for more information”
Note: There is no validation on the country/region code value.
To View Country or Region Code:
Command Syntax show serial modem country code
This command is supported on s1 only.
Description
Displays the supported country/region codes for this product.
Default Value
-
Success
OK
Error 1. Too few arguments
Possible value(s) are:
configuration
chat-script
country/region-code
modem-configuration
statistics
Countries/Regions Supported
See the list on the Multi-Tech Web site for countries and regions supported.
Go to:
http://www.multitech.com/PRODUCTS/Info/approvals
Then click on global modems. The Global Modem Country/Region Approvals page displays. On this page you can
view approvals, configuration strings (which includes the country/regional code) and responses available in list form
by selecting country/region and/or product.