User guide

Operation and Maintenance MultiVOIP User Guide
462
5. After the PC gets a response from the MultiVOIP, the Dialog – IP
Parameters screen will appear.
The user should verify that the correct IP parameter values are listed
on the screen and revise them if necessary. Then click OK.
6. Progress bars will appear at the bottom of the screen during the data
transfer.
The MultiVOIP’s “Boot” LED will turn off at the end of the transfer.
7. The Download Factory Defaults procedure is complete.
Downloading IFM Firmware (Analog Voips only)
The Interface Module (IFM) is the telephony interface for analog
MultiVOIP units (MVP130, MVP130FXS, MVP210, MVP410, MVP810).
There is one IFM for each channel of the MultiVOIP unit. For each
channel, the IFM handles the analog signals to and from the attached
telephone, PBX or CO line. The IFM communicates with the main
processor indicating the status of the telephone line. For example, it