User's Guide

Page 17
Equipment Installation
2.4 Wiring up the CS100 Base Station
To wire up the CS100 Base Station, remove the front facia by gently
releasing the 4 clips on the rear of the unit. At the top of the circuit board,
there is a screw keeping the board in place – remove this screw to release
the board from the case. Follow anti-static precautions while handling the
PCB. Now follow these steps:
1. Carefully remove the circuit board from the housing
2. Cable can be inserted through any of the 4 passages in the base
of the housing. Remove the ‘Break out’ tab from the cable
passage convenient to your installation
3. Insert the cabling through the hole
4. Secure the cable using the bracket and screws provided
5. Connect the wires into the connector at the bottom of the circuit
board