System Manual

EkoTek System Installation and Configuration Manual

9261-8173 issue: 8 Page 23

2. Installing the hub and IP slave hub

The hub can be freestanding on a desk, or wall mounted using the screws provided.

To remove the cover, depress the two protruding plastic tabs and separate the top

from the back plate.

Wall mounting

Mark the position of the screws on the wall. The two screws should be spaced

precisely 120mm apart, as shown in the diagram of the back plate below:

Drill two holes with a 5mm masonry bit to a depth of 25mm.

Insert the wall plugs and screw the screws. Leave 7mm of the screw

protruding. (Note: Screws and plugs not provided).

Locate the screw heads in the holes in the back-plate and pull the unit down to

lock into place.

120mm