System Manual

EkoTek System Installation and Configuration Manual
9261-8173 issue: 8 Page 40
© 2012 Multitone Electronics Plc
9. Scroll the new window and select the ‘Internet Protocol TCP/IP’ menu item.
10. Click the ‘Properties’ button.
11. The default shipped configuration for the hub is:
IP address: 192.168.1.2 (1.1.1.1 if via PPP serial port)
Subnet mask: 255.255.0.0
Default gateway: 192.168.1.20
In order to communicate between the PC and the hub, the IP address of
the PC has to be set to the same network and subnet as the hub. To
achieve this select ‘Use the following IP addresses and enter the IP
address in the same range as the hub (in the example above
192.168.1.100 and a subnet mask of 255.255.0.0 Gateway 192.168.1.20).
12. Click ‘OK’ to finish.
Using the web browser to access the hub
In the address field of the web browser, type the IP address of the hub (default
is 192.168.1.2 for Ethernet) and click the refresh button. The browser then
connects to the hub web interface.