System Manual

EkoTek System Installation and Configuration Manual

9261-8173 issue: 8 Page 55

Details

Hub, IP slave hub and call point

Name

The name of the hub or call point may be changed, by entering a new name in

the box.

Device mode

The hub or call point is allocated a device mode (1-32), with 1 as default.

However, the name for each device mode can be user configured, in which

case different options will appear in this menu. The device mode defines the

behaviours of all similar devices (radio channel, alarm raising ability, etc). See

the ‘Device mode’ section (page60).

User group

Select from the drop list, to set ‘User Group’ (1-16). Used to route alarms to

different pager groups.

Zone

Fixed devices are allocated a zone number, allowing alarms from mobile

devices to be sent to different pager groups based on the hub or repeater (and

therefore zone) that the mobile device is connected to, and for directly raising

location alarms. Up to 16 zones are supported by the EkoTek system.

After selecting the device mode parameters, click ‘Submit’ to enter the

changes.

Repeater and solar repeater

Name

The name of the repeater may be changed, by entering a new name in the box.