User's Manual

155
105
Dimensions in mm
PSG/10290-1
RPT 633
Page 4 - 2 TM1184 Issue 1
INSTALLATION
Positioning
CAUTION
DO NOT MOUNT OVER A HEATER OR RADIATOR, OR IN DIRECT SUNLIGHT
AND ENSURE A DRY ENVIRONMENT.
2. Carefully unpack the transmitter, power supply and antenna. Site the transmitter and
power supply in a convenient working position within reach of an AC power outlet
and within 1km of the encoder.
Shelf Mounting
3. Lay the transmitter on a suitable horizontal shelf on its integral mounting feet
(sloping panel upwards). Connect the antenna as indicated in paragraphs 5 or 6
and the remainder of the electrical connections as paragraph 7.
Wall Mounting
4. Mark and drill the wall as shown, suitable for No 8 plugs and round-head screws.
Insert screws into plugs with the top of the screw head a maximum of 10mm from
the wall and the bottom of the screw head a minimum of 5mm from the wall.
Remove the rubber pads from the bottom of the base tray and hook the transmitter
onto the screws. The transmitter can be mounted either antenna up or antenna
down.
Figure 1: Mounting Hole Diagram