User's Manual

TM 1184 Issue 1 AL1 (May 1997) Page A1 - 11
Time-of-Day This is a dummy User / Receiver which is used to allow the Time and/or Date
User Number to be set. If a call is sent to this receiver then the message content is used to set
the system Time and/or Date as follows:
a) To set the Time, the Time-of-Day User is called with a 4-digit message in the
form: ‘HHMM’ where:
HH represents the Hours digits (00 - 23)
MM represents the Minutes digits (00 - 59)
b) To set the Date (Mk7 only), the Time-of-Day User is called with a 6-digit
message in the form: ‘YYMMDD’ where:
YY represents the last two digits of the Year (00 - 99)
MM represents the Month of the Year (01 - 12)
DD represents the Day of the Month (01 - 31)
c) As an alternative, a 10-digit numeric message in the form <<YYMMDDHHMM’
will set both Time and Date together.
NOTE: Mk6 paging receivers must be programmed with System Size
set to ‘10,000’ and System Type set to ‘Other’.
25. Once set-up is complete, turn off the power supply and disconnect the PC.