Owner’s Manual Easy Close™ Gate MK0002-022 Rev 3 KEEP FOR FUTURE REFERENCE Please read the instructions carefully before installing this gate. For additional help, installation videos are available at www.munchkin.
Contents IMPORTANT INFORMATION Introduction............................................................................................................................................ 3 Disclaimers ............................................................................................................................................ 3 Warnings ................................................................................................................................................
Getting Started Getting Started INCLUDED PARTS STEP 1: IDENTIFY GATE PLACEMENT If any parts are missing or damaged, please contact our Customer Satisfaction Team at 1-800-344 -2229. For maximum security, DO NOT use this gate in any location without installing all 4 wall cups, sticky pads and screws provided. In some openings only 2 top wall cups can be fitted. The gate must be installed between two structurally sound surfaces.
To Install To Install STEP 2: VERIFY PROPER WIDTH STEP 3: REMOVE EXTENSION Measure the width of the opening where the gate will be installed. Be sure to measure at the narrowest point between the walls. For example, include any baseboards in your measurement. Then, see below for the proper gate configuration for your opening. TOOLS NEEDED: Tape measure TOOLS NEEDED: Flathead screwdriver 1.
To Install To Install STEP 4: INSTALL WALL CUPS 6a. For Drywall Without Stud / Plasterboard: Drill a 7/32”(5.5mm) hole into the drywall at the center mark. Insert a drywall anchor. TOOLS NEEDED: • Drill • Phillips Screwdriver • Pencil Peel the back off the sticky pad that is attached to the wall cup. Then stick the wall cup onto the wall to fit your pencil marks. 1. Ensure the wall cups are on the end of 4 adjustment rods. 2.
To Install To Install STEP 5: MOUNT YOUR GATE 1. Place the gate where your want to install it, then extend all 4 adjustment rods until they reach the walls. Ensure that the ends of the adjustment rods are seated inside the cups. TOOLS NEEDED: Wrench 2. Use the wrench to tighten the nuts on all 4 threaded adjustment rods until the gate is secure. Tighten each nut a little at a time, starting at the bottom of the gate, then move to the upper hinge-side, and lastly the upper handle side. 2 3.
How to Use OPENING YOUR GATE ADJUSTING THE SWING GUARD Push the button on top of the handle with your thumb, then squeeze the trigger on the handle’s underside at the same time. Pull the handle upward to swing the gate open. If the gate is placed at the top or bottom of stairs, always lower the swing guard into its locked position on the opposite side of the gate from the stairs. This prevents the gate from opening into the stairway.
Customer To Install Service Customer Service EXTENSION CONFIGURATIONS ONE-YEAR LIMITED WARRANTY Additional extensions can be purchased at www.munchkin.com A. Munchkin, Inc.’s safety gates include a one-year limited warranty from the date of purchase. POLICY: In the event of a malfunction or defect during the in-warranty period, Munchkin, Inc., at its option, will replace or repair a gate under warranty. Munchkin, Inc.’s limited warranty extends only to the gate’s original purchaser. Small 2.
Customer Service C. CONSUMER REIMBURSEMENT: Munchkin, Inc. does not provide refunds as a remedy for defective or nonconforming safety gates. Nor does Munchkin, Inc. offer cash back for returned product purchased through any of Munchkin, Inc’s safety gate websites. Exception: Munchkin, Inc. will provide cash back refund on purchases made through any of Munchkin, Inc.’s safety gate websites ONLY if there was a processing or shipping error made by Munchkin, Inc.