Instructions / Assembly

To Install To Install

6 7

STEP 2: VERIFY PROPER WIDTH

Measure the width of the opening where the gate will be installed. Be sure to measure

at the narrowest point between the walls. For example, include any baseboards in your

measurement. Then, see below for the proper gate conﬁguration for your opening.

35.4”  37.8” 89.9CM  96CM

Skip to page 8.

33” - 35” (83.8CM - 88.9CM)

Proceed to page 7.

29.5”  32.5” 75CM  82.5CM

Proceed to page 7.

Please see page 14 for additional extension conﬁgurations.

TOOLS NEEDED:

Tape measure

Remove 1 small extension

Remove 2 small extensions

STEP 3: REMOVE EXTENSION

1. Remove the adjustment rods and plugs from the

upper and lower side of the gate you are removing

the pre-installed extension from. You may need to use

a ﬂathead screwdriver to remove the plugs.

2. Remove the pre-installed extension by pulling out the

upper and lower extension adapters away from the

gate. Store the extension in a safe place in case you

move the gate to a wider opening in the future.

3. Reinsert the plugs and adjustment rods you removed

earlier back into the gate. Please be sure the slot on

the plug is facing down towards the ﬂoor. Adjustment

rods slide into the plug holes. They DO NOT screw.

PLEASE NOTE: For opening 29.5”- 32.5” (75cm-82.5cm),

repeat these steps on the other side of the gate to remove

the second extension. To add an extension, simply reverse

the instructions.

TOOLS NEEDED:

Flathead screwdriver

Bottom plug

Slot