Instructions / Assembly

To Install To Install
8 9
STEP 4: INSTALL WALL CUPS
1. Ensure the wall cups are on the end of 4 adjustment rods.
2. Temporarily place the gate where you want to install
it, flush against the floor. Pull the adjustment rods out
until they reach the walls and trace the position of
each wall cup with a pencil.
3. Retract the adjustment rods and set the gate aside
for now.
4. Hold the wall cup in position and mark the center with
a pencil. Then put the cup aside.
5. Determine whether there is a stud behind the drywall
where you will install each wall cup. Proceed to either
6a or 6b.
PLEASE NOTE: The gate should be resting on the floor.
DO NOT allow a gap of more than 0.196” (5mm) between
the gate and the floor.
TOOLS NEEDED:
• Drill
• Phillips Screwdriver
• Pencil
Floor
Gate
2
4
6a. For Drywall Without Stud / Plasterboard:
Drill a 7/32”(5.5mm) hole into the drywall at the
center mark. Insert a drywall anchor.
Peel the back off the sticky pad that is attached to
the wall cup. Then stick the wall cup onto the wall to
fit your pencil marks.
Use a screwdriver or drill to insert the screw through
the center of wall cup into the drywall anchor.
6b. For Drywall with Stud:
Drill a 5/64”(2mm) pilot hole into the stud
(no anchor needed).
Peel the back off the sticky pad that is attached to
the wall cup. Then stick the wall cup onto the wall to
fit your pencil marks.
Use a screwdriver or drill to insert the screw through
the center of the wall cup into the stud.
Drywall
Plasterboard
Stud
Drywall
Anchor