Instructions / Assembly

To Install To Install
10 11
STEP 5: MOUNT YOUR GATE
1. Place the gate where your want to install it, then extend all 4 adjustment rods until
they reach the walls. Ensure that the ends of the adjustment rods are seated inside
the cups.
2. Use the wrench to tighten the nuts on all 4 threaded
adjustment rods until the gate is secure. Tighten each
nut a little at a time, starting at the bottom of the
gate, then move to the upper hinge-side, and lastly
the upper handle side.
3. The nuts should be tightened until the handle latch
locks into the frame.
PLEASE NOTE: DO NOT overextend
the adjustment rods. If the gate is
more than 2.5” from the wall, you must
add an extension. See page14 for
additional extension configurations.
2
3
1/16”
(1.5mm)
<2.5”
(<63.5mm)
<2.5”
(<63.5mm)
TOOLS NEEDED:
Wrench