User Guide

How to Use How to Use
8 9
1. Choose the correct adapter for your baby
bottle (see Included Adapters on page 7).
Ensure the gaskets are installed in the warming
unit and adapter (gasket identication letter
facing up).
Screw the adapter into the neck of the warming
unit.
If no adapter is needed, proceed to step 2.
2. Fill the baby bottle with water (for formula) or
breast milk.
NOTE: Warm water rst, then mix in powdered
formula once heating cycle is complete.
For best results do not use to heat premixed
formulas or alternative milks.
3. FLIP THE WARMING UNIT UPSIDE DOWN
and screw the baby bottle into the unit or
adapter. Twist until the bottle is pressed rmly
against the gasket to ensure a watertight seal.
BEFORE YOU BEGIN
FOR USE WITH ROOM-TEMPERATURE OR REFRIGERATED LIQUIDS ONLY. FROZEN
BREAST MILK MUST BE THAWED BEFORE USING THIS APPLIANCE.
The warmer should not be powered ON without a baby bottle lled with water or breast
milk installed on the warmer.
Three dashes “_ _ _” on the front of warmer
indicates that the warmer’s heating plate has
overheated.
Under this scenario, you must wait 15 minutes
before the unit is ready for use.
Warmer may overheat if used improperly.