User Guide

How to Use How to Use
10 11
~4 mins
~5 mins
~6.5 mins
~5.5 mins
~7 mins
~9 mins
STARTING MILK TEMPERATURE
72°F (22°C) 42°F (5°C)
VOLUME
4oz/120ml
6oz/180ml
8oz/240ml
4. Open the rubber cover on the back of the
warming unit, then insert the power cord. Plug
the cord into an electrical outlet.
The standby mode is ready and display will
blink 00.0, it will automatically stop after 30
seconds if no action is taken.
NOTE: When the warmer turn off after 30
seconds of no action. PRESS AND HOLD the
button once for 2 seconds to activate the
standby mode. Next PRESS and HOLD again
for 2 seconds to activate the heating cycle.
5. Make sure the warming unit is right side up
when standby mode is ready and then press
and hold the power button for two seconds to
start warming. The digital 98.C display will turn
on.
NOTE: Based on most common standard sized bottles.
~4 mins means “approximately 4 minutes”
The warming durations are to be used as a guide only. Bottle style and size, liquid starting
temperature and volume can impact the warming speed and nal temperature.
For optimal heating temperature use with 4oz to 8oz of liquid.
6. When the liquid reaches approximately 98.6°F,
the warming unit will beep to indicate the
cycle is complete. The liquid will be kept at this
temperature for up to 15 minutes after the cycle
is complete. After the 15 minutes the warming
unit will auto shut off.
NOTE: To ensure your liquid is warmed properly,
wait until the end of the warming cycle before
removing the bottle.
7. When ready to remove the bottle, press and
hold the power button for two seconds to turn
off the unit. Then unplug the cord from the
unit and the wall outlet. Flip the device upside
down, unscrew the baby bottle and shake the
bottle well to ensure proper heat distribution.
Always check the liquid’s temperature before
feeding.
NOTE: Warming a second bottle –
Allow at least 5 minutes for the unit to cool
before next use.
ON/OFF: Press and hold for
2 seconds
WARMING TIMES