User Guide
How to Use How to Use
12 13
HOW TO CLEAN
DESCALE
TROUBLESHOOTING
De-scale your bottle warmer after every use to ensure residual deposits are removed from
the heating plate and the silicone seal. To de-scale, mix 15ml (0.5oz) of white vinegar with
15ml (0.5oz) of cold water and pour into the heating plate. Allow liquid to stand in the
unit until any deposits (limescale) have dissolved. Discard liquid and wipe heating plate
with a damp cloth. Repeat process if necessary.
To avoid bacteria growth, perform “Cleaning” and “De-Scaling” after every use.
Blinking display: Digital Bottle Warmer will not operate if tilted more than 30°. Place
warmer on a at and stable surface.
Overheat protection: Power switch turns off after three consecutive beeps – circuit
protection detects rapid increase in internal temperature to prevent damage to the device.
Three beeps: Digital Bottle Warmer will power off due to limescale deposit build up on
heating plate or if breast milk has not been mixed thoroughly.
Display “E1": Digital Bottle Warmer is not responding to input command from the control
panel due to not functioning temperature sensor.
Display show "E2": Digital Bottle Warmer is not responding to input command from the
control panel due to not functioning heating element.
For “E1” and “E2” errors, please contact our Customer Satisfaction team at
1-800-344-2229 (M-TH 8:00am-5:00pm PST, F 8:00am-1:00pm PST) or visit our website at
www.munchkin.com.
Always unplug unit and ensure that it is cool before cleaning. Do not use scouring pads,
abrasives or solvents for cleaning; they may damage the appliance and its surface. Place
the rubber plug back into the plug attachment to prevent water intrusion and cause
electrical short during cleaning.
Digital Bottle Warmer: Wipe all surfaces with a damp cloth or sponge using mild liquid
soap, rinse with clear water. Allow to air-dry. Do not submerge unit in liquid.
Adapters and Gaskets: Wash with mild liquid soap
and rinse with clear water. Allow to air-dry. Always
replace gaskets to their proper locations (gasket
identication letter facing up).
Keep Dust Cover on when not in use to keep
heating plate clean.