User`s manual

ML180-MLT350 Dehumidifiers

190TGB-1034-A 2 Installation 9

2.6 Location Requirements

The dehumidifier is intended for indoor installation.

It is important that the intended installation site meets the location and

space requirements for the equipment in order to achieve the best

possible performance and trouble-free operation.

The unit should be placed in an upright level position inside or outside

the space to be dehumidified.

For unit and service dimensions, see section 6.3, Dimensions and service

space.

NOTE! It is important, both for maintenance and for service, that the minimum service

space for service access are compiled with.

2.7 Process and Dry Air Connections

The front and back panels are interchangeable, so that the connections

for process and dry air may be situated either on the left or right side of

the unit.

ML-Series dehumidifiers are delivered with the process and dry air

connections on the left side of the unit. If it is required to the change

the orientation, so that the connections are on the right side of the

unit, proceed as follows:

WARNING! Ensure that mains power is isolated from the dehumidifier prior to

changing the orientation of the process and dry air connections.

1. Remove the two bolts (B) securing the front panel and carefully

remove the panel.

2. Remove the two bolts securing the rear panel and carefully remove

the panel.

3. Remove the two bolts (A) and washers, securing the control and top

panels to the unit and carefully remove the top panel.

4. Remove the cable duct covers (C), re-route the cables and fit the

control panel (D) to the opposite side of the unit. Refit the cable

duct covers.

5. Refit the front, rear and top panels in the new position.

Figure 2-2. Changing panel orientation