Integration Guide

WIT2410

Protocol Modes Definitions

mode 00 Transparent mode used for point-to-point networks

or multipoint remotes; does not support any packet

types.

mode 01 This is the simplest protocol mode supporting Data

packets only. This mode is not recommended for

base radios. No CONNECT or DISCONNECT

packets are supported and no sequence numbers are

provided.

packet types supported: Data

mode 02 This mode includes notification when remotes are

registered or dropped through CONNECT and

DISCONNECT packets that are sent to the user

application at the base station and at the remote. No

sequence numbers are provided.

packet types supported: Data

CONNECT

DISCONNECT

mode 04 This is the packet format used by the WIT2400.

This allows legacy software to operate the

WIT2410 with a minimum of changes. Note

however, that since different air data rates are used,

WIT2410s and WIT2400s cannot be mixed in a

network.

packet types supported: 2400 data format

(addresses must be limited to 1..62)

modes 05 – 08 reserved for future use.

mode 09 This mode sends the protocol mode 01 packets

during transmit but receives data transparently.

mode 0A This mode sends the protocol mode 02 packets

during transmit but receives data transparently.

mode 0C This mode sends the protocol mode 04 packet

during transmit but receives data transparently.

modes 0D – 0F reserved for future use.

mode 11 This mode sends data transparently but supports

protocol mode 1 during reception.