User's Manual

WIT2410P

To change configuration parameters, the radio must be put into configuration mode by

clicking on the Config Mode button on the WinCOM window immediately after opening

WinCOM or after cycling power to the radio. Another method is to toggle the DTR by

pressing the F1 key twice, which de-asserts then re-asserts DTR, then pressing the F3 key

(or Config Mode button).

When the radio is in configuration mode, a “>” prompt character is displayed in the

WinCom window as shown above. Configuration parameters are sent to the radio by

entering them in the WinCom window after the “>” prompt and pressing the Enter key.

If an invalid command or value is entered, the radio will respond with “Error” as shown

above Until the command to save the parameters (

) is issued, the new parameters will

only be valid until power is cycled or DTR is toggled by pressing the F1 key twice.

New parameter values that have been issued are saved to non-volatile memory using the

“m>” command. Refer to the Memory Commands section for details on this and other

helpful memory commands.

To exit configuration mode from the WinCom screen, use the “z>” command and press

Enter as shown below.

The return to the data mode is indicated by an absence of the “>” prompt. Refer to the

Configuration Commands section below for details on all the configurable parameters.

When the radio is linked to another radio, a communications test can be run by clicking

on the Transmit button or pressing the F6 key. Whatever ASCII string is in the Transmit

String window will be transmitted as shown below.