Data Sheet
Table Of Contents
- Revision History
- Table of Contents
- 1 Introduction
- 2 Mechanical Specification
- 3 DC Electrical Specification
- 4 RF Specification
- 5 Environmental Specification
- 6 Power Sequence
- 7 Application Information
- 8 Application Reference
- 9 Assembly Information
- 10 Packaging and Marking Information
- 11 Regulatory Information
- 12 RoHS Information
- 13 Ordering Information
- 14 Notice
- 15 Preconditions To Use Murata Products
Copyright © Murata Manufacturing Co., Ltd. All rights reserved. October 2017
MBN52832 Data Sheet, v1.3, 11/13/2018 Page 28 of 34 www.murata.com
11 Regulatory Information
The table below shows the regulatory compliance status of the MBN52832 module.
Table 12.1 Regulatory Standards Conformance
Regulatory Body
Standard
Certificate ID
FCC
Part 15
HSW2832
IC
RSS-210
4492A-2832
ETSI
EN300 328, Ver. 2.1.1
ETSI EN301.489 - 17
Compliant
TELEC
Article 38-24 Paragraph 1
of the Radio Law
001-P1041
BT SIG
BT 5.0
Declaration ID: D036210
QDID: 97989
MBN52832 also has been certified with a particular external antenna (see table below ).
Table 12.2 External Antenna to comply with FCC and IC
Part Number
Vendor
Gain (dBi)
Type
Connector
Remarks
S2406PL Cushcraft 6.0 Patch U.FL
Necessary for FCC/IC
compliance only.
HG2407RD-RSP L-Comm 7.0 Dipole U.FL
Necessary for FCC/IC
compliance only.
To be compliant with RED Directive while using MBN52832 module with external antenna, the total EIRP including the
antenna gain should be less than or equal to 10dBm.
11.1 FCC Notice (USA)
Warning: Changes or modifications to this device not expressly approved by Murata could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
The FCC requires the OEM to be notified that any changes or modifications not expressly approved by Murata may void
the user’s authority to operate the equipment. While an application of the MBN52832 module in a product is not required to
obtain a new FCC authorization for the module, this does not preclude the possibility that some other form of authorization
or testing may be required for that end product.
This device using the integrated antenna has been tested to comply with FCC CFR Part 15. The device meets the
requirements for modular transmitter approval as detailed in the FCC 47 CFR 15.212.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver.