User's Manual

WLAN61xxEB CF EVK User’s Guide

SyChip Confidential Page 7 of 29 SyChip WLAN61xxEB CF EVK

4 Driver Setup for Pocket PCs

Along with the WLAN61xxEB EVK package, there is a User’s Manual for Pocket PCs.

Based on the evaluation platform you use, refer to the appropriate sections in the enclosed document for

installation and usage instructions. The manual provides easy to follow step-by-step directions. Anyone

can set up and configure a laptop computer or a Pocket PC to communicate with a host or enterprise hub

following these steps. Some information will be needed about the network hub to enable

communications. If you do not know your ESSID or your encryption algorithm, contact your in-house IT

support person or system administrator.

4.1 Installing driver on Pocket PCs

The current way to install the driver on a Microsoft based Pocket PC is to run an installation (.CAB) file

inside the Pocket PC. You can also run an installer program (.EXE) on a PC while connecting your

Pocket PC via ActiveSync.

4.1.1 Using CAB file installation via SD memory card

1. Insert the CD with SyChip driver software into the CDROM drive of your notebook computer.

Copy SYEBCE4_XX.CAB file from the CD to the SD memory card.

2. Insert the SD memory card into the SD Slot of the Pocket PC, use the File Explorer on the Pocket

PC and navigate to the memory card location. Click on the SYEBCE4_XX.CAB file to start

installation.

4.1.2 Using CAB file installation via sync cable

1. Copy the SYEBCE4_XX.CAB

file from the CD to the Pocket PC after ActiveSync is established.

2. Use the File Explorer on the Pocket PC and navigate to the CAB file location. Click on the

SYEBCE4_XX.CAB file to start installation.

4.1.3 Using InstallShield via sync cable from a PC

1. From My Computer on your desktop find CD drive that holds the WLAN61xx driver software,

and run the SYEBCE4_XX.exe executable file.

2. Follow the on-screen instructions to finish the installation procedures.

3. Disconnect the sync cable

4.2 Uninstalling the SyChip driver Software

To remove the program, follow Settings->system-> Remove Programs on the mobile device. Select the

“Sychip Cheetah WLAN CF Card function” and click “Remove”.

Note: if the WLAN61xxEB EVK card is inserted and in service, you will get an error message. Please

remove the card before uninstalling the software.

If it is for Magneto, use SYEBCE5_XX.CAB; for CE.Net 4.20, use SYEBCN4_XX.CAB, accordingly.