User Manual

Page 61 of 90
CCT24
4.2.14 Protocol Mode Event Message Example
In this example, the IO_ReportInterval is set to 10 seconds and the periodic report timer bit in the
IO_ReportTrigger parameter is set on the remote, with MAC address 0x123456. This causes event mes-
sages to be sent from this remote every 10 seconds. The IO_ReportInterval and the IO_ReportTrigger
parameters are loaded using SetRemoteRegister commands. The command to set the IO_ReportInterval
to 10 seconds is:
0xFB 0x0B 0x0B 0x56 0x34 0x12 0x1A 0x06 0x04 0xE8 0x03 0x00 0x00
The IO_ReportInterval parameter starts in location 0x1A of bank 0x06. The report interval is set in 10 ms
units, so a 10 second report interval is 1000 units or 0x000003E8 (Little-Endian format E8 03 00 00). The
IO_ReportInterval parameter is updated and SetRemoteRegisterReply is returned:
0xFB 0x06 0x1B 0x00 0x56 0x34 0x12 0xC4
The command to set the periodic report timer bit in IO_ReportTrigger to is:
0xFB 0x08 0x0B 0x56 0x34 0x12 0x19 0x06 0x01 0x10
The periodic report timer bit in IO_ReportTrigger is located in bit position four (00010000b) or 0x10. The
IO_ReportTrigger parameter is updated and SetRemoteRegisterReply is returned:
0xFB 0x06 0x1B 0x00 0x56 0x34 0x12 0xC4
The remote will start sending event messages on 10 second intervals as shown in the log records below:
FB 16 28 56 34 12 CB 00 05 0E 01 00 00 00 01 01 F9 01 DF 01 C9 01 10 00
FB 16 28 56 34 12 B6 00 05 0E 01 00 00 00 01 01 F8 01 DF 01 CC 01 10 00
FB 16 28 56 34 12 B3 00 05 0E 01 00 00 00 01 01 F8 01 E0 01 CC 01 10 00
FB 16 28 56 34 12 B1 00 05 0E 01 00 00 00 01 01 F9 01 DF 01 C9 01 10 00
FB 16 28 56 34 12 AE 00 05 0E 01 00 00 00 01 01 F9 01 DF 01 C8 01 10 00
FB 16 28 56 34 12 AD 00 05 0E 01 00 00 00 01 01 F9 01 E1 01 CF 01 10 00
IO_ReportTrigger generates RxEvent messages (PktType 0x28). The message payload consists of the
first 14 bytes in Bank 5, including the state of GPIO0 through GPIO5, the input voltages measured by
ADC0 through ADC2, and the state of the event flags. Note the ADC readings and the event flags are
presented in Little-Endian order.