User Manual

Page 68 of 90
CCT24
Connect PCs to both the Base and the Remote for serial communication testing. Click the Stop button
under the Refresh Delay label on the I/O Tools tab and move to the Transmit Tools tab, as shown in
Figure 5.6.2.1.
Figure 5.6.2.1
Pressing the Transmit button on this screen sends the message in the Data to Transmit text box to the
selected MAC Address. Note that the MAC address a remote uses for the base is always 0x000000.
Data sent to the local radio is displayed in the Received Data text box. Received data can be displayed
as ASCII (default) or in Hexadecimal format by checking the Hex Mode check box. When the Transmit
Interval is set to zero, Data to Transmit is sent once when the Transmit button is clicked. When the
Transmit Interval is set to a positive number, Pressing the Transmit button once will cause a transmission
each transmit interval (seconds) until the button is pressed again.