User Manual

Page 76 of 90
CCT24
Click on Connect to open the Select Comm Port Settings dialog box, as shown in Figure 5.7.2. Set the
baud rate to 9600 (9.6 kb/s). Set the CommPort to match the serial port connected to the Base, either the
hardware port or the USB virtual serial port. Then click OK to activate the serial connection.
Figure 5.7.2
At this point the Wizard will collect data from the Base, filling in data under Current Settings as shown in
Figure 5.7.3. The Status Window should also show that the Remote has joined the Base.
Figure 5.7.3