User Manual

Page 78 of 90
CCT24
Figure 5.7.5
The Transmit Data tab is shown in Figure 5.7.5. The message to send is input in the Data to Transmit text
box. The address to send the message can be chosen or input in the MAC Addr drop-down box. Note
that the MAC address a remote uses for the base is always 0x000000. If the Transmit Interval is set
to 0, the message is sent once each time the Transmit button is clicked. When the Transmit Interval is set
to an integer greater than zero, the message will sent at the beginning of each interval until the Stop
button (was Transmit button) is clicked. The status of each transmission is shown below TX Data Reply.
Figure 5.7.5 shows that the transmitted message was ACKed, with the received signal strength of the
ACK -66 dBm.