User's Manual

ManualsBrandsMurata Manufacturing ManualsElectronicsWLAN module compatible with IEEE802.11b/g/n (HT20)

11 November 2020

User Manual for FCC

Since this module is not sold to general end users directly, there is no user manual of

module.

For the details about this module, please refer to the specification sheet of module.

This module should be installed in the host device according to the interface specification

(installation procedure).

FCC ID:VPYLB1YA

Application Product Name: Communication Module

Application Type name: Type1YA, Type1YB

Summary of content (8 pages)

PAGE 1
User Manual for FCC Application Product Name: Communication Module Application Type name: Type1YA, Type1YB FCC ID:VPYLB1YA Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation procedure). Copyright © Murata Manufacturing Co., Ltd. All rights reserved.
PAGE 2
User Manual for FCC This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with below part 15 of FCC Rules. Part 15 Subpart C The modular transmitter is only FCC authorized for the specific rule parts (i.e.
PAGE 3
User Manual for FCC Operating temperature Range and Supply Voltage Power Levels and Scan mode mode Rate Channel IEEE 802.11b 1Mbps 2Mbps 1~11 MAXIMUM TUNE UP TOLERANCE [dBm] 10.5 ± 1.5 13.0 ± 1.5 Other rates IEEE 802.11g All Rates 1~11 13.0 ± 1.5 IEEE 802.11n(HT20 only) All Rates 1~11 13.0 ± 1.5 Frequency of operation 2.4GHz 11b/g/n (HT20) 2412-2462MHz Scan Ad-hoc mode Active Yes End users can not modify the software because F/W & driver are installed in device.
PAGE 4
User Manual for FCC Antenna information Antenna Product Name: Type1YA internal antenna Antenna Type: Inverted F Antenna Max Peak Gain: 1.6dBi @ 2400-2483.5MHz Copyright © Murata Manufacturing Co., Ltd. All rights reserved.
PAGE 5
User Manual for FCC ●The host device that builds in this module must contain the following statement Contains Transmitter Module FCC ID:VPYLB1YA or Contains FCC ID: VPYLB1YA This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 6
User Manual for FCC ●When installing it in a mobile equipment. Please describe the following warning to the manual. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body. ●When installing it in a portable equipment. Please describe the following warning to the manual.
PAGE 7
User Manual for FCC About preparation and flow for SAR test at host equipment Contact to Murata Murata Provide sample Murata provide a few module samples with an RF connector attached. And the power setting condition data ( patha value ) of the sample and USB UART Adapter are also provided.
PAGE 8
User Manual for FCC Murata re-connects the RF line to the antenna. And re-provide to you. Murata will reconnect the antenna for samples whose power measurement results in the test lab are within 2 dB of the maximum power specified in the product specifications. You incorporate the sample into the host equipment. Connect the 3UART lines to the USB-UART Adapter and the sample. 3 UART lines are attached Power to the module is supplied by the host Transmission control at 11b/11Mbps/1ch.