User's Manual

External Dipole Antenna
4.75
1
UNII-3
PCB Antenna
3.3
External Dipole Antenna
4.75
The PCB Antenna is permanently attached, can’t be replaced.
There is only one antenna port, which is shared by all the radios by time divided.
The module doesn’t have a permanent antenna. The following antennas are certified to be
FCC/ISED regulatory conformity.
(a) Monopole PCB antenna with peak gains of 3.0dBi (2.4GHz) and 3.3dBi (5GHz);
(b) External dipole antenna with peak gains of 3.4dBi (2.4GHz) and 4.75dBi (5GHz);
Notice to OEM integrator
Must use the device only in host devices that meet the FCC/ISED RF exposure category of
mobile, which means the device is installed and used at distances of at least 20cm from
persons. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
The end user manual shall include FCC Part 15 /ISED RSS GEN compliance statements
related to the transmitter as show in this manual(FCC/ICanada statement). Host manufacturer is
responsible for compliance of the host system with module installed with all other applicable
requirements for the system such as Part 15 B, ICES 003. Host manufacturer is strongly
recommended to confirm compliance with FCC/ISED requirements for the transmitter when the
module is installed in the host.
Must have on the host device a label showing Contains FCC ID: VPYLB2AE，IC: 772C-LB2AE
The use condition limitations extend to professional users, then instructions must state that this
information also extends to the host manufacturer’s instruction manual.
This module is stand-alone modular. If the end product will involve the Multiple simultaneously
transmitting condition or different operational conditions for a stand-alone modular transmitter in
a host, host manufacturer have to consult with module manufacturer for the installation method
in end system. Any company of the host device which install this modular should perform the
test of radiated & conducted emission and spurious emission etc. according to FCC Part 15C:
15.247 and 15.209 &
15.207, 15B class B requirement, only if the test result comply with FCC part 15C: 15.247 and
15.209 & 15.207, 15B class B requirement. Then the host can be sold legally.
This modular transmitter is only FCC authorized for the specific rule parts ( 47CFR Part 15.247
and 15.407) listed on the grant, and that the host product manufacturer is responsible for
compliance to any other FCC rules that apply to the host not covered by the modular transmitter
grant of certification. Host manufacturer is strongly recommended to confirm compliance with
FCC/ISED
requirements for the transmitter when the module is installed in the host. Must have on the host
device a label showing Contains FCC ID: VPYLB2AE and Contains IC: 772C-LB2AE
l'hôte doit utiliser l'instrument uniquement dans des dispositifs qui répondent à la fcc / (catégorie
d'exposition rf mobile, ce qui signifie le dispositif est installé et utilisé à une distance d'au moins
20 cm de personnes. le manuel de l'utilisateur final doit inclure la partie 15 / (fac rss gen dé
clarations de conformité relatives à l'émetteur que de montrer dans ce manuel. le fabricant est
responsable de la conformité de l'hôte, le système d'accueil avec le module installé avec toutes
les autres exigences applicables du système comme la partie 15 b, ices - 003. accueillir le