Data Sheet

MBN52832 Data Sheet, v1.4a, 02/06/2020 Page 21 of 34 www.murata.com

9 Assembly Information

The recommendation conditions of soldering are as in the following figure.

When products are immersed in solvent after mounting, pay special attention to maintain the temperature difference within

100 °C. Soldering must be carried out by the above mentioned conditions to prevent products from damage. Set up the

highest temperature of reflow within 260 °C. Contact Murata before use if concerning other soldering conditions.

Reflow soldering standard conditions

Figure 9.1 Reflow Profile

Please use the reflow within 2 times.

Use rosin type flux or weakly active flux with a chlorine content of 0.2 wt % or less.

Since this Product is Moisture Sensitive, any cleaning is NOT permitted.