Manualshelf

Installation Instructions

ManualsBrandsMURATA ManualsElectronicsThis electronic pet door is designed to allow the pet access to go outside when needed without assistance
12345678910
9
Installing the pet door in a metal door without adapters
1. Place the spacer at the bottom of the cut opening, in the middle.
2. Insert the interior frame into the opening on the interior side of the door, on top of the spacer. Make sure the interior frame is
centered in the opening.
3. Insert the exterior frame into the opening on the exterior side of the door, fitting it over the tunnel of the interior frame.
Holding both frames in place, insert screws through the holes in the exterior frame, through the cutout opening and into the
holes on the back of the interior frame.
The pet door came with two lengths of screws; choose the screws that best fit the thickness of your door.
4. Using a manual Phillips screwdriver, tighten the screws just until the frames are attached. Do not tighten fully yet.
5. If needed, adjust the position of the pet door; it should be resting on the spacer and centered horizontally in the opening.
6. Hold the pet door in place and finish tightening the screws with a manual Phillips screwdriver. Do not overtighten.