Datasheet

Chip Ferrite BeadChip EMIFILr
Chip Common Mode Choke Coil
Block Type EMIFILrMicrowave Absorber
!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
sales representatives or product engineers before ordering.
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
C31E.pdf
09.4.20
182
Microwave Absorber
Notice
1. Adhesive Tape Stress
This product is designed for using the adhesive tape
to hold itself to the object.
And please avoid causing mechanical stress by
bending or variation of the object.
2. Cleaning
Avoid cleaning product.
3. Handling of the Product
Adhesive tape must be clean to maintain the quality
of tape.
And please wipe off any dirt, dust and any kind of oil
from the surface of the object before use.
Flat cable
Stress
Products shall be located in the sideways
direction to the mechanical stress.
Product
poor example
good example
4. Storage Conditions
(1) Storage Period
Products which were inspected in Murata over 6
months ago should be examined and used. This can
be confirmed with inspection No. marked on the
container.
Adhesiveness should be checked if this period is
exceeded.
(2) Storage Conditions
· Products should be stored in the warehouse on the
following conditions.
Temperature: -10 to +40˚C
Humidity: 30 to 70% relative humidity
No rapid change on temperature and humidity
· Products should be stored in the warehouse without
heat shock, vibration, direct sunlight and so on.
● Storage and Operating Conditions
Notice