User's Manual

17 / 1
Preliminary & Confidential
< Specification may be changed by Murata without notice >
Reflow Soldering Standard Conditions (Example)
Please use the reflow within 2 times.
Use rosin type flux or weakly active flux with a chlorine content of 0.2 wt % or less.
13.6 Cleaning :
Since this Product is Moisture Sensitive, any cleaning is not permitted.
13.7 Operational Environment Conditions :
Products are designed to work for electronic products under normal environmental conditions (ambient
temperature, humidity and pressure). Therefore, products have no problems to be used under the similar
conditions to the above-mentioned. However, if products are used under the following circumstances, it
may damage products and leakage of electricity and abnormal temperature may occur.
- In an atmosphere containing corrosive gas ( Cl2, NH3, SOx, NOx etc.).
- In an atmosphere containing combustible and volatile gases.
- Dusty place.
- Direct sunlight place.
- Water splashing place.
- Humid place where water condenses.
- Freezing place.
If there are possibilities for products to be used under the preceding clause, consult with Murata before
actual use.
As it might be a cause of degradation or destruction to apply static electricity to products, do not apply
static electricity or excessive voltage while assembling and measuring.
13.8 Input Power Capacity :
Products shall be used in the input power capacity as specified in this specifications.
Inform Murata beforehand, in case that the components are used beyond such input power capacity
range.
Within 120 s
Pre-heatin
g
time(s)
220 °C
Within 60 s
Cooling down
Slowly
180 °C
150 °C
240 ~ 250 °C
Within 3 s