Datasheet

!
Note
• Please read rating and
!
CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifi cations. Therefore, please approve our product specifi cations or transact the approval sheet for product specifi cations before ordering.
144
GRM Series GJM Series GMA Series GMD Series GQM Series GRJ Series GR3 Series KRM Series KR3 Series LLA Series LLL Series LLM Series LLR Series
!
Caution
Continued on the following page.
Continued from the preceding page.
<Applicable to Temperature Characteristics X7R (R7),
X7T (D7) beyond Rated Voltage of 200VDC>
1-2. The load should be contained so that the self-heating of
the capacitor body remains below 20°C, when
measuring at an ambient temperature of 25°C. In
addition, use a K thermocouple of ø0.1mm with less
heat capacity when measuring, and measure in a
condition where there is no effect from the radiant heat
of other components or air flow caused by convection.
Excessive generation of heat may cause deterioration
of the characteristics and reliability of the capacitor.
(Absolutely do not perform measurements while the
cooling fan is operating, as an accurate measurement
may not be performed.)
<Applicable to Temperature Characteristics U2J (7U),
C0G (5C) beyond Rated Voltage of 200VDC>
1-3. Since the self-heating is low in the low loss series, the
allowable power becomes extremely high compared to
the common X7R (R7) characteristics.
However, when a load with self-heating of 20°C is
applied at the rated voltage, the allowable power may
be exceeded. When the capacitor is used in a
high-frequency voltage circuit of 1kHz or more, the
frequency of the applied voltage should be less than
500kHz sine wave (less than 100kHz for a product with
rated voltage of DC3.15kV), to limit the voltage load so
that the load remains within the derating shown in the
following figure. In the case of non-sine wave,
high-frequency components exceeding the fundamental
frequency may be included. In such a case, please
contact Murata. The excessive generation of heat may
cause deterioration of the characteristics and reliability
of the capacitor.
(Absolutely do not perform measurements while the
cooling fan is operating, as an accurate measurement
may not be performed.)
The temperature of the surface
of capacitor: 125°C or less (including self-heating)
The sine-wave frequency VS allowable voltage
C0G (5C) char., Rated Voltage: DC500V
C0G (5C) char., Rated Voltage: DC250V
Frequency [kHz]
100
(250)
Allowable Voltage [Vp-p]
1000
C0G (5C) char., Rated Voltage: DC630V
Frequency [kHz]
1000100101
100
(630)
Allowable Voltage [Vp-p]
1000
1000100101
to 470pF
1,000pF
680pF
560pF
820pF
to 1000pF
Frequency [kHz]
100
(500)
Allowable Voltage [Vp-p]
1000
1000100101
Frequency [kHz]
100
(200)
Allowable Voltage [Vp-p]
1000
1000100101
to 330pF
C0G (5C) char., Rated Voltage: DC200V
C0G (5C) char., Rated Voltage: DC1kV
Frequency [kHz]
1000100101
100
(1000)
Allowable Voltage [Vp-p]
10000
to 100pF
to 560pF
820pF
680pF
1,000pF
!
Caution