Data Sheet

Preliminary Specification Number : SP-ZZ1PJ-331-K
34 / 44
Preliminary & Confidential
< Specification may be changed by Murata without notice >
Murata(China) Investment Co., Ltd.
19.5. Soldering Conditions:
The recommendation conditions of soldering are as in the following figure.
When products are immersed in solvent after mounting, pay special attention to maintain the
temperature difference within 100 °C. Soldering must be carried out by the above mentioned
conditions to prevent products from damage. Set up the highest temperature of reflow within 260 °C.
Contact Murata before use if concerning other soldering conditions.
Reflow soldering standard conditions(Example)
Please use the reflow within 2 times.
Use rosin type flux or weakly active flux with a chlorine content of 0.2 wt % or less.
19.6. Cleaning:
Since this Product is Moisture Sensitive, any cleaning is not permitted.
19.7. Operational Environment Conditions:
Products are designed to work for electronic products under normal environmental conditions (ambient
temperature, humidity and pressure). Therefore, products have no problems to be used under the
similar conditions to the above-mentioned. However, if products are used under the following
circumstances, it may damage products and leakage of electricity and abnormal temperature may
occur.
- In an atmosphere containing corrosive gas ( Cl
2,
NH
3,
SO
x,
NO
x
etc.).
- In an atmosphere containing combustible and volatile gases.
- Dusty place.
- Direct sunlight place.
- Water splashing place.
- Humid place where water condenses.
- Freezing place.
If there are possibilities for products to be used under the preceding clause, consult with Murata before
actual use.
As it might be a cause of degradation or destruction to apply static electricity to products, do not apply
Within 120s
Pre-heating
time(s)
220 deg.C
Within 60s
Cooling down
Slowly
180 deg.C
150 deg.C
235 to 245 deg.C
Within 3s