Data Sheet

Preliminary Specification Number : SP-ZZ1PJ-331-K
40 / 44
Preliminary & Confidential
< Specification may be changed by Murata without notice >
Murata(China) Investment Co., Ltd.
within 20cm.
Mobile equipment : Equipment used at position in which the spaces between human body and antenna
exceeded 20cm.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
3-a) The use of an monopole PCB antenna with gain less than 2.0 dBi(2.4GHz), 2.0
dBi(5.15~5.35GHz), 1.2 dBi (5.47~5.725GHz) and 1.0 dBi (5.725~5.85GHz).
3-b) The use of a PIFA antenna with gain less than 3.29 dBi(2.4GHz) and 4.32 dBi (5GHz).
As long as 3 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements
required with this module installed
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining
a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such
that 20 cm may be maintained between the antenna and users. The final end product must be labeled
in a visible area with the following: “Contains FCC ID: VPYLBEE5ZZ1PJ”. The grantee's FCC ID can be
used only when all FCC compliance requirements are met.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or remove this RF module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.