Datasheet

Inrush Current Suppression Lead Type !Caution/Notice
41
8
!Note
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
■ !Caution (Storage and Operating Conditions)
■ !Caution (Others)
Be sure to provide an appropriate fail-safe function
on your product to prevent secondary damages that may be
caused by the abnormal function or the failure of our
product.
■ Notice (Storage and Operating Conditions)
To keep solderability of product from declining, the
following storage condition is recommended.
1. Storage condition:
Temperature -10 to +40 degrees C
Humidity less than 75%RH (not dewing condition)
2. Storage term:
Use this product within 6 months after delivery by
first-in and first-out stocking system.
3. Handling after unpacking:
After unpacking, reseal product promptly or
store it in a sealed container with a drying agent.
4. Storage place:
Do not store this product in corrosive gas
(Sulfuric acid gas, Chlorine gas, etc.) or in direct
sunlight.
■ Notice (Rating)
Use this product within the specified temperature
range.
Higher temperature may cause deterioration of the
characteristics or the material quality of this
product.
■ Notice (Soldering and Mounting)
1. Be sure that the preheat-up does not melt the
soldering of this product. Excessive heat may
cause failure to open, short or insulation break
down.
2. Do not touch the body with soldering iron.
The soldering point should be min. 5mm away from
the root of lead wire.
1. This product is designed for the Switching Power
Supply with smoothing capacitors.
Other applications of this product may result in
fire.
2. Use this product within the specified maximum
current. Otherwise it may catch fire in the worst
case.
3. Use this product with smoothing capacitor within
the specified maximum capacitance value. Otherwise
it may catch fire in the worst case.
4. This product is designed for application in an
ordinary environment (normal room temperature,
humidity and atmospheric pressure).
Do not use under the following conditions because
all of these factors can deteriorate the product
characteristics causing failure and burn-out.
(1) Corrosive gas or deoxidizing gas
(Chlorine gas, Hydrogen sulfide gas, Ammonia
gas, Sulfuric acid gas, Nitric oxide gas, etc.)
(2) Volatile or flammable gas
(3) Dusty conditions
(4) Under high or low pressure
(5) Wet or humid conditions
(6) Near with salt water, oils, chemical liquids or
organic solvents
(7) Strong vibrations
(8) Other places where similar hazardous conditions
exist.
!Note
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please review our product specifications or consult the approval sheet for product specifications before ordering.
R44E.pdf
Feb.21,2011