Operations Manual

8800-45001.A
This document contains proprietary and confidential information originated or owned by Cubic. Neither this document nor the
information disclosed herein shall be reproduced or transferred to other documents or used or disclosed to others for
manufacturing or any other purposes except as specifically authorized in writing by Cubic.
06 Oct 2022
2-3
• MasterCard
®
M/Chip
• Visa
®
Contactless Payment Specification (VCPS)
• American Express
®
ExpressPay
• Discover
®
Network (D-PAS)
• MIFARE DESFire™ EV1, EV2
• MIFARE Classic™
• MIFARE Ultralight C™, MIFARE Ultralight™
• MIFARE Plus™
2.1.1.3 Audio Output
The validator has one speaker below the center of validator which plays audio tones corresponding to valid
and invalid taps.
Characteristics of the audio interface include the following:
• One weather-resistant speaker emits audio tones or voice instructions using wav resource files.
• Tone frequency and duration is software configurable through substitution of audio resource files.
• Audio volume is software adjustable and is capable of 70dB at maximum from 1 meter away.
The validator can communicate with an existing vehicle logic unit (VLU) / Transit Control Head (TCH) using
the available connectivity, like Ethernet RJ-45.
2.1.2 Device Communications
The device sends and receives information through ports and wireless communication.
2.1.2.1 Ethernet
The validator provides an RJ-45 connection for provision of 10/100/1000 Base-T Ethernet. Ethernet is routed
from the host device through the Personality Module to the POI device. Within the Personality Module, any
power from a power over Ethernet supply is taken off before passing the Ethernet signals to the POI device
via an adapter cable.
2.1.2.2 Bluetooth
Bluetooth connectivity is provided for configuration and diagnostics. The validator supports:
• Bluetooth 5
• Bluetooth Low Energy (BLE)
2.1.2.3 Serial
The validator provides a serial output via RS-485.
2.1.2.4 USB
The validator has two internal USB 2.0 connectors, which are intended for use during setup, maintenance and
are not available while pole mounted.