Operations Manual

06 Oct 2022
This document contains proprietary and confidential information originated or owned by Cubic. Neither this document nor the
information disclosed herein shall be reproduced or transferred to other documents or used or disclosed to others for
manufacturing or any other purposes except as specifically authorized in writing by Cubic.
8800-45001.A
2-6
 Expansion port 2 USB 2.0 (not available while pole mounted) Serial RS232/RS485
(software selectable); Micro SD card for additional memory capacity
2.1.6.4 Temperature and Humidity
The temperature and humidity design targets are:
• Humidity range of 10 to 97 percent, non-condensing relative humidity
• Temperature range of -16.6 °F to 149 °F operating with solar load from direct sunlight through bus
window and -22 °F to 176 °F storage
2.1.6.5 Startup Time
Cold boot—From application of power to validator ready is less than two minutes.
2.1.6.6 Design Life and Reliability
Design life and reliability are described in Table 2-1.
Table 2-1. Design Life and Reliability
Item Description
Design Life Validator components are designed to support a usable life of 12 years or greater.
Mean Cycles Between
Failure
Mean cycles between failures (MCBF) is no less than 75,000 if maintenance
guidelines are followed. Failures connected with mishandling, vandalism, and
misuse are not covered within the MCBF figure.
Mean Time to
Remove/Replace
The Mean Time to Remove and Replace (MTTR) the validator is less than 7
minutes.
2.1.6.7 Security and PCI Compliance
The inside of the validator is only accessible when it is removed from the pole it is mounted on. The validator
is locked to the pole-mount by a high security Medeco lock. All data is securely retained in the validator, which
is PCI compliant. The secure module reader used in the validator is:
• Secure Reading and Exchange of Data (SRED) compliant with the POI security standard.
• Certified to PCI PTS standard for POI devices.
The keys are stored on a tamper resistant area of the POI device reader within the validator and are injected
in a secure facility at the Cubic Manufacturing Facility in Tullahoma, TN.
2.1.6.8 Entry Validation Transaction Time
The design for the transaction time from properly presented media to response on the validator display is less
than 500 microseconds. Reading and processing of the media has the greatest variability because of the
different form factors and implementations.