Operations Manual

8800-45001.A
This document contains proprietary and confidential information originated or owned by Cubic. Neither this document nor the
information disclosed herein shall be reproduced or transferred to other documents or used or disclosed to others for
manufacturing or any other purposes except as specifically authorized in writing by Cubic.
06 Oct 2022
4-3
4.2.1 Visual Inspection
Visually inspect the validator each day for the following:
• Check exterior surfaces for grease, grime, dirt, or any other signs of wear, vandalism, or damage.
• Check the structural integrity.
• Clean if needed.
4.2.2 Cleaning
CAUTION
To prevent damage to the devices, do not use abrasive or metallic scrub
pads for cleaning surfaces. Use only clean, lint-free cloths dampened as
described in Table 4-1.
To clean the validator:
Step 1. Dampen a clean, lint-free cloth with water and detergent solution (see Table 4-1 for details)
and wipe the surfaces to remove accumulated dirt and grime from the housing. Use the
solution sparingly for best results.
Step 2. Remove surplus cleaner with a clean damp (water only), lint-free cloth.
Step 3. Dampen a clean, lint-free cloth with Windex and wipe the validator front glass.