All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
6-11us I n G f-c o d e f e a t u r e s
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
us I n G f-c o d e b o x f e a t u r e s
Sending a document using a subaddress and password
1
Switch to the fax mode by pressing
<
c o p y
4
f a x
4
s c a n
>
.
2
Place the document on the ADF or document glass.
Adjust the document mode and contrast if necessary.
3
Press <Advanced Functions> until “F-Code Tx” appears on the LCD then press
<Enter>.
F-Code Tx
/
/Enter
– or –
Press the “F-Code Tx” soft key.
Enter Sub-Address
_
4
Use the numeric keys to enter the appropriate ITU-T subaddress.
Then press <Enter>.
Enter Password
_
The password setting is optional, but required if the other party has set a password on
their F-code box.
5
Use the numeric keys to enter the ITU-T password.
Then press <Enter>.
If you do not need to enter ITU-T password, press <Enter> without entering any num-
ber.
Enter Fax Number
_
6
Enter the fax number.
You may use a one-touch key, speed-dial number or the numeric keys to enter the fax
number.
7
Press <Start>. Your machine begins scanning the document.
Then, your machine
dials and sends the document with the subaddress and password.
To cancel the sending in progress, press <Job Confirm./Fax Cancel> and <Cancel>, <Can-
cel>.
To cancel the delayed sending, press <Job Confirm./Fax Cancel>, search the command
number you want to cancel using the cursor key, then press <Cancel>, <Cancel>. (See
also “Reviewing or canceling command” on page 4-8.)
NOTE:
•
The document glass is available only for the MFX-1950.
•
If you frequently dial the same destination with a subaddress (and password), use the
macro key at your convenience. For details of the macro key, see page 8-4.