All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
7-3co p y I n G
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
co p y I n G
Making copies
Making copies using the ADF
1
Switch the machine to copy mode by pressing
<
c o p y
4
f a x
4
s c a n
>
.
Copy Ready 01
Auto Ltr 100%
2
Place your document face up on the ADF and adjust the document guides to the docu-
ment size.
3
As needed, set the copy settings including the
document type and scanning contrast,
number of copies, zoom ratio and sort setting. See “Basic copy settings” on page 7-4.
To clear the settings, press <Reset>.
4
Press <Start> to begin copying.
To stop copying, press <Stop>.
Making copies using the document glass
The document glass is available only for the MFX-1950.
1
Switch the machine to copy mode by pressing
<
c o p y
4
f a x
4
s c a n
>
.
Copy Ready 01
Auto Ltr 100%
2
Make sure that there is no document on the ADF. If a document is on the ADF, it
takes priority over the document on the document glass.
3
Place your document face down on the document glass and align it to the upper left
corner. Then close the platen cover.
4
Press <Doc. Size> to select the document size, Letter,
Half-letter
or Legal.
5
As needed, set the copy settings including the
document type and scanning contrast,
number of copies, zoom ratio and sort setting. See “Basic copy settings” on page 7-4.
To clear the settings, press <Reset>.
6
Press <Start> to begin copying.
To stop copying, press <Stop>.