All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
7-8 co p y I n G
Combine
This feature allows you to copy two one-sided documents to one sheet of Letter-sized paper.
Document orientation on the ADF
or document glass*
Result image of combined copy
1
1
2
2
* The document glass is available only for the MFX-1950.
NOTE: • WhenusingtheADF,enlargementcopyisnotavailable.
•Thismachinehasnoimagerotationfunction.
1
Make sure the machine is in the copy mode.
2
Place your document on the ADF face up or on the document glass face down.
3
To make the combine copy available:
For MFX-1950
— Press <Combine>. The light above the <Combine> key will illumi-
nate, which means the combine key is turned on.
For F-315 — Press <Advanced Functions> repeatedly until
“Combine” appears, then
press <Enter>. And turn on “Combine” using the cursor key and press <Enter>.
4
Set the following as needed. (See “Basic copy settings” on page 7-4.)
•Documenttypeandscanningcontrast
•Numberofcopies
•Zoomratio
(25 to 400% for the document glass, 25 to 100% for the ADF.)
To reset the copy parameter to the default setting, press <Reset>.
5
Press <Start>.
To stop the copying, press <Stop>.