All in One Printer User Manual
Table Of Contents
- Preface
- The manuals for your machine
- Contents
- How to read this manual
- Regulatory information
- Limited warranty
- Precautions
- Chapter1 Layout & Installation
- Chapter2 Getting started
- Chapter3 Autodialler
- Chapter4 Sending faxes
- Chapter5 Receiving faxes
- Chapter6 Using F-code box features
- F-code: an introduction
- Creating or modifying an F-code box
- Printing a list of F-code boxes
- Printing a list of documents stored in your F-code boxes
- Erasing an empty F-code box
- Storing a document in a bulletin box for polling
- Printing a document stored in a bulletin box
- Erasing a document stored in a bulletin box
- Printing a document received in the security box
- Sending a document using a subaddress and password
- Polling a document using a subaddress and password
- Chapter7 Copying
- Chapter8 Special features
- Chapter9 Security features
- Security features
- Using department codes
- Turning department code protection ON and OFF
- Entering a department code
- Erasing a department code
- Turning the department code setting on and off
- Fax charge setting
- Copy charge setting
- Sending a fax using a department code
- Making a copy using a department code
- Printing the department code list
- Resetting the department code counter
- Copy protection
- Chapter10 User settings
- Chapter11 Report & Lists
- Chapter13 Maintenance & Problem solving
- Appendix & Index
7-11co p y I n G
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
co p y I n G
Copy resolution
Both machines offer the highest copy quality available. However, this feature also
requires more memory than with normal copy resolution. If you try to copy several
pages at a time, memory overflow may occur.
1
Make sure the machine is in the copy mode.
2
Place your document in ADF face up, or on the document glass face down.
3
Press <Doc. Resolution>.
Resolution :300dpi
t
Photo&Text
u
4
Press <q>, <p> or <Doc. Resolution> to select “600dpi”.
Resolution :600dpi
t
Photo&Text
u
5
Set the following as needed. (See “Basic copy settings” on page 7-4.)
•Documenttypeandscanningcontrast
•Numberofcopies
To reset the copy parameter to default setting, press <Reset>.
6
Press <Start> to begin copying.
To stop copying, press <Stop>.
NOTE: The document glass is available only for the MFX-1950.